Technologies for Energy

Project summary

POWER TECHNOLOGIES FOR SALE

"ENERGY CONVERTER" AND "ENERGY MULTIPLIER" BUILT ON ITS BASE

1. ENERGY CONVERTER

This device is a converter of reactive energy into active energy. Only reactive current is supplied to the input of the device, which has a maximum offset from the voltage with a recommended angle φ of at least 90⁰ . At the output, active power is generated. Regardless of the load at the output of the inverter, the power at the input of the inverter remains exclusively reactive . The device is self-stabilized. Does not require electronic control systems. Has no electronic components. Has no moving wear parts. Demonstration of work of the reactive energy converter

Capacitive reactive energy converter properties:

1. The angle φ practically does not change with the magnitude of the load;
2. With an increase in the load (up to the full power mode) at the input of the active power converter does not appear and a decrease in reactive power is observed;
3. The converter output behaves like a current source;
4. There is a dependence on the position in space - if you turn the converter, then a slight change in the output characteristics is observed (video material on the change in characteristics when the position in space changes is impossible to shoot due to the failure of the smartphone and digital camera during other experiments);

2. ENERGY MULTIPLIER BUILT ON THE BASE OF THE ENERGY CONVERTER

The energy multiplier is based on a reactive-to-active energy converter. It works most effectively with an active reactive RL load, where all powers are multiplied, both reactive Q , and active P , and full S - that is, at the output of the multiplier, and Q , and P , and S more than at the input of the multiplier. Link to a video demonstrating the operation of the multiplier

Checked by an independent specialist - an active power engineer. The check was carried out using advanced methods of high-precision digitization of parameters at the input and output of the multiplier, followed by the calculation of the integral powers in a specialized software and computer complex. Before checking, a set of measurements and calculations of errors and introduced parameters of the measuring and working equipment was carried out, followed by the creation of a table of corrections and corrections, which were already taken into account in direct measurements and in calculations of the multiplier processes.

The conclusion of a specialist - the effect has no explanation within the framework of existing theories and models of Physics, Electrodynamics, Theory of Electrical Machines.

In the course of the examination, the main source element of the multiplier circuit was identified, which is the direct initiator of the multiplication process, which created the preconditions for assumptions about the possibility of further increasing the efficiency of the power multiplication process.