Gravity engine

Project summary

The proposed mass propeller-gravitational engine consists of a housing 1 having guides 2, in which weights 3 are movable along each other, which are in gear engagement with a gear wheel 4 having a shaft 5. With guides 2, weights 3 interact through wheels 6 , connected in pairs by axes 7, which are in weights 3 with the possibility of rotation. For normal interaction with the wheel 4, the weights 3 have recesses 8, and to reduce friction when they slide over each other, the weights 3 have recesses 9, in which the balls 10 are located.
The proposed mass propulsion-gravitational engine works as follows. For its operation as a propeller, the wheels 5 from the shaft 5 (in Fig. 1 are shown with an arrow) are rotated from the drive and the housing 1 moves in the direction of the arrow shown in Fig. 1, since the mass of loads 3 located on top is always greater than - from below, since the mass of loads 3 located on top is always greater than - from below, since they are located almost vertically, their number is greater. If we rotate the housing 1 by 90 * around the axis of shaft 5 in the direction of the arrow, then for the same reasons we get a gravitational engine with the removal of torque in the same arrow from shaft 5.
I have declared 12 inventions called "The Gravitational Engine". Nowadays, there are many such devices in books and on the Internet. Mine are not much different from them, although some are well "advanced". A prototype was made for me at the Motor Sich plant (see the photograph - I am holding it in my hands with the cover removed for a good overview), and below, see the description on the application with a drawing in the attached file. Its tests showed that in gravitational engines, the displacement of the center of mass from the axis of rotation creates centrifugal forces, which make it practically with very low efficiency.